Industrial Wireless Radio Controls
Please
request a quotation
Supply power |
120/240VAC or
12VDC / 5watt |
Inputs |
N/O Normally
Open, digital dry contact |
Transmitter power |
per
FCC Part 15.249,
50mV/m @ 3m |
Transmission |
Digital Encoded
Gaussian_frequency-shift_keying |
Channels |
16 addresses per system
GFSK |
Input Wiring |
Din Terminals,
Dry Contact |
Response |
Loop 500 msec
|
Weight |
2 lb (1.40kg)
each unit |
Module |
Module with Terminals, screw mounting |
Specifications
Digital Receiver
|
Supply power |
120/240VAC or
12VDC / 5watt |
Output |
Relay 10Amp, Class 2 pilot duty
SPDT |
Frequency |
27MHz •
License free MURS band |
Configuration |
DIP switch factory
preset |
Compliance |
FCC CFR part 15.247, 95 sub E |
Wiring |
Screw Terminals |
Antenna Z |
50 Ohm, SO-239 |
Ambient temp |
14° to 140° F (-10° to 60°
C) |
Enclosure |
Weatherproof, IP65
9"W x
9"H x
4"D (230 x 230 x 100 mm) |
Transmission Mode |
Special
Options: |
■
Continuous
(1) ■ Off Delay Timing ■ Pulse Output
■ Latching
for each
channel
|
■
Fail Safe sequence module
■
Battery Backup module
■ Repeaters and extended range systems
■ High, Low Status level indicator lamp
■ Automatic Start/Stop module
|
(1)
FCC
Part 95,
subpart B |
Optional
Modules Selection |
Package Kit:
One Base
Transmitter, One Base Receiver
Two 34" Omni Antennas with 10ft coaxial cable, Enclosures &
Instructions
Compliance:
MIL-STD-461E
for
Electro-Magnetic
Interference
(EMI) MIL-STD-901D
Grade A for High
Impact Shock MIL-STD-167B
for Vibration
FCC
CFR part 15.247, 95 sub B and E
OPTIONAL
(*)
FailSafe OPERATION: Transmitter sends an interval pulse
as long as the input (1) is activated by a control, switch
or sensor etc. The Receiver Ch1 at the other end
turns the output(1) ON, decodes the interval to verify the
status of the transmitter, If The Transmitter,
Finalize the control action open the circuit, loss of power or carrier,
then The receiver decoder will acknowledge and turn the
Receiver output (1)OFF until the signal is activated again
|
|
|
Long
Range Wireless Systems 27MHz
The potential range is
approximately 6 miles* and,
with proper antenna
application, is not limited to line of sight. |
|
■
Applications:
Industrial Monitoring, Pump control, Monitor remote
sites, Tank Level,
Lighting control, Remote Mobile system, PLC remote, SCADA,
Gates.
Factory process control, Alarms, Generators,
Solar, Wire replacement.
Performance
•
5 miles ( 10 km )
line-of-sight w Omni antenna • Extended range up to 20 km
• Operation
Selection: 120/240VAC, 12VDC,
or 24V •
Transmitter input N/O Dry contact
• Relay Output SPDT, 10A @250VAC
Class 2
• Momentary Pulse Output
•
Heavy Duty Weatherproof, IP65 enclosure
• License free operation
at the 11meter band • Factory configured systems, Ready to operate
• No setup or programming required
• Not limited to line-of-sight
communication |
Migro27-4
Four (4) channel configuration
Part
927042 12VDC
Part
927047 120/240VAC
■
Request a
Quotation |
|
OPTIONAL 4 Channels Virtual Continuous
operation module ( Fail-Safe) |
|
|
927144 Four (4) channel continuous
mode module,
OPERATION: Transmitter sends an interval
pulse as long as the input is activated by a
control, switch or sensor etc. The Receiver at
the other end decodes
the interval to verify the status of the
transmitter
then turns the output relay ON, If the Transmitter, Finalizes the
control action, or a power or carrier loss
occurs, then the Receiver decoder will
acknowledge, and turn the Receiver output
OFF.
Lead time ( Off delay 30 seconds)
Fail Safe module, Reset when: Power fails,
Carrier failure or end of transmission control
Complies with FCC part 15.247 sub E on
Continuous transmission timing
9FS4 Receiver
Module
Operating voltage 12VDC
Input: Dry Contact,
Output: 8A SPST
Enclosure Weatherproof IP65, 9x9x4 inches
|
|
|
•
Antenna
Range Calculator
Please
Request latest price |
27MHz Omni Antenna 36 inch Quarter Wave (3 foot)
Frequency |
26 to 29 MHz |
Gain |
3.5 dBi |
Vertical Beam |
30 degrees |
Impedance |
50 Ohms |
Connector |
SO-239 |
Max Power |
150 Watts |
VSWR |
< 1.5:1 avg. |
Polarization |
Vertical |
10 Feet of 50 ohm coaxial
cable,
connectors and mounting kit
Part # 937099
|
|