Wireless Controls & Automation
  Home Contact Shopping Cart   Site Map
   

 Wireless Two (2) Channel Remote Digital Controller


Base   937411 
Please request  for price
 Special order
 


WIRING


  3 Miles ( 5 km ) line of sight
  4600 feet (1400m) partially obstructed
  Optional extended range up to 20 Miles (32Km)

  Transmitter & Receiver easy to install:  # 937411

1  Base Transmitter dry contact input w Solar Panel, Battery & Controller
1  Base Receiver pre-wired,  With mode controller
2  Antenna 36 inch  with coaxial  cable & PL259 connector
2  NEMA 4 Die cast metallic enclosure for wall or pole mount
    Instructions & wiring diagram 
Specifications
 

 SPECIFICATIONS 
Operating Voltage: 12 VDC
Operating Temperature: -4 to +140 F (-20 to +60 C)
Number of Codes:  64000 codes, DIP switch programming
Carrier Frequency 27 MHz , 16 BIT Digital
Current Transmitter Standby 15 A, transmitting -2.0 Amps (1 Sec)
Current  Receiver Standby  25 mA, operation, 65 mA
Data Input TX  Dry contact 
Relay Output 10 Amp max  250VAC, 30VDC, Class II pilot duty
Antenna Impedance 50 Ohms Quarter Wave Antenna optional
Dimensions Receiver: 24.13 x 19.05 x 8.89 cm / 9.5  x 7.5 x 3.5 inch
Weight 8 lb. (4 Kg) each
Enclosure  Receiver NEMA 4   IP65 metallic waterproof
Compliance per FCC Part 15.249,  50mV/m @ 3m
 
 
 ACTION  Transmitter    :    Receiver
Momentary: Close switch CH 1 :    Turn ON,
Close switch CH 2 :    Turn OFF
Continuous: Close switch CH 1 :    Turn ON,
Close switch CH 2 :    Turn OFF

  

 Optional Accessories


  Contactors Mechanical Float Switch
   

    DISCLAIMER:    Contact a licensed professional for your project.   Warning: Radio control equipment is not to be used in life safety  

     Copyright   Electrodepot. All rights reserved   2795