Wireless Controls and Automation
   
 
Industrial Wireless Radio Controls Modules
Panel Mount Ready UPS Battery Backup System
 
Performance
■ 1 Mile (2.km) line-of-sight 938432 ant.
■ 3 Miles (5 km) line-of-sight 938433 ant.
■ Optional long range 5 Miles ( 8 km )
■ Input Dry isolated contact N/O
■ Relay output  6 Amp 240V/30V
   

Installation features
■ Operation license-free 433MHz ISM band
■ Easy installation,
No programming
■ Panel mount or clip onto DIN-35mm rail

 
 Operation   Transmitter Receiver
 Continuous: Close switch
Open switch
Relay ON
Relay OFF
.

Applications:
Industrial Monitoring,
Pump control, Monitor remote
instruments, sensors,
Lighting, Packing and mobile system,
PLC remote, SCADA,
Factory process control
Generators. Remote alarms.
Solar, Wire replacement

Specifications

Wiring Example 12VDC*

Wiring Example 120/220VAC*

.

   9UPS81   Single (1) Channel  Transmitter and Receiver Set

 1 CH  9UPS81 System    $879.95      (*) Special Order     Add the Antennas

 Additional Receiver 1 Channel
1 CH  9UPS81R 
 $578.95      (*) Special Order     Add the Antennas


    9UPS82   Two (2) Channel  Transmitter and Receiver Set

 2 CH  9UPS82 System    $999.95     (*) Special Order       Add the Antennas

 Additional Receiver 2 Channel
1 CH  9UPS82R 
 $629.95      (*) Special Order     Add the Antennas


 

  System with Battery Charger and UPS
 
Specifications:
AC input range: 90 - 264VAC
Output 1: Load output voltage: 12Vdc
Current range: 0 - 2.9 Amp
Output 2: Battery output voltage: 13.8Vdc
Charging current: 1.0 Amp

934012UPS Module Charges the battery,
Alarm signal for AC Ok and Battery Low
Battery low cut off/ reverse protection
Protection: shortcut/ over load / over voltage

    Typical 12Ah battery may provide 3 day backup

      Battery not included


 
(*)
Special Order,  Please allow 4 days factory delivery
  

   Specifications      Digital Transmitter
Supply power 12 VDC @ 400 mA
Inputs  N/O Normally Open, digital dry contact
Transmitter power per FCC Part 15.249,  50mV/m @ 3m
Transmission Digital Encoded   Gaussian_frequency-shift_keying
Channels 16 addresses per system  GFSK
Input Wiring Din Terminals,  Dry Contact
Response Loop 500 msec
Weight 0.8 lb (0.40kg)  each unit
Dimensions 4.50 x 3.50 x 3.25 in. /  (114.30 x 88.90 x 86.75 mm)

   Specifications      Digital Receiver 
Supply power 12 VDC  @ 300 mA
Output   Relay SPST  contact 6.Amp, 30V/240vac  Class 2 pilot duty
Frequency 433 MHz  • License free Industrial ISM band
Configuration DIP switch factory preset
Compliance FCC CFR part 15.247, 95 sub E
Wiring Components mounted on 35mm DIN rail
Antenna Z 50 Ohm SMA RF connector
Ambient temp  14 to 140 F (-10 to 60 C)
DIN Rail  IP22, UL94-5VA, DIN mount 35mm or panel mount

       Optional Enclosure NEMA 4
■ Fiberglass enclosure
■ Pole or wall mount ready
■ Screw hinged cover, with
■ Aluminum internal sub panel
■ UL/cUL NEMA/CSA 4
■ UL #E345005

    DIMENSIONS

 

  971206     $179.99    


 

 

 

930080 series



DISCLAIMER:  Radio control equipment in not to be used in life safety.
Radio Installations shall be performed by a certified professional.

 




Antenna Selection ( TWO  are required )
 



938433  Yagi antenna 12 E

 14 dBi  5 Mile+
 Length: 43", Weight: 3.lb

 with 10 ft coax cable and connector

  938433     $369.99    

 




938455,  5 E  Yagi Antenna

Gain: 9 dBi  3 Mile+

433 MHz, Rating: 150 Watts
Impedance 50 ohms  N terminal
Vertical beam 55 degrees -
 Horizontal beam 60 degrees
With N female termination
Base Length: 32", Weight: 4.0lb

938433   $249.99       



 

938432   Yagi antenna 3 E

7 dBi  1 Mile+
Length: 18", Weight: 1.lb
with 10 ft coax cable and connector

  938432     $179.99    


 



 


938092

938092


 14" Omni Antenna 

3 dBi  1500ft line of sight
10ft coax cable
  SMA

  938092    $39.99    

 



 


938091

938091

 6" Omni Antenna 

0 dBi Short range
5ft coax cable
  SMA

 

  938091     $19.99    


 
Add   Accessories:
 


Contactors


933020 Miniature Contactor

20A, 3 Pole, 12VDC Coil
2HP @240V, 7.5HP @460V
1HP @120V,  
4 KW@ 220V
20Amp AC-1, 12Amp. AC-3
1 N.O. Aux.,
Dimension: 1.7 x 2.5 x 2.3 in 
 (45 x 64 x 58 mm)
Surface or DIN rail mountable

  933020     $49.99    

.

7 Day 24 Hour Timer
 DIN rail,  
Manual - Auto
 SPDT 16A, 250V Pilot Duty,
 Dim: 3.5H, 1.5W, 2.7D inches
3 Year Battery backup,
16 time schedules 

Manual

934012  12VDC  $49.99 

 

 

934135
Multi function Timer or Latch


Electronic  timer   DIN mount 
Time from
0.1s  to 10 days
SPDT relay 10A N.O. and N.C
12,24 VDC  24,110,220 VAC

Specifications
 

934135   $98.99

 

 

 

Mechanical Float Switch 

  930650     $69.99    

 

     Copyright   Electrodepot. All rights reserved